This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADSync Filter- V7.1.1

Hello,

Is it possible to setup a filter for ADSync in synceditor to just populate ADSContainer table, for example? We tried couple of things but didn't seem to work. Please advise

Thanks in advance,

0 Barry Jackson over 8 years ago

Hi,

Not sure why you would want to do this but in the workflows section of the sync editor simply disable or delete all the workflows except for container.

HTH, Barry.
Cancel
Up 0 Down

Cancel
0 smmellac over 8 years ago

Thanks Barry. This worked. Where can i put the filter so i can sync users from a specific OU only? In 6.1.3 we used to be able to do this in Manager under "Configure Sync"

Please advise
Cancel
Up 0 Down

Cancel
0 Tomi Kääriäinen over 8 years ago

Please define a scope under Target system. Then choose only the wanted OUs.

Here the explanation what is a scope:
support.quest.com/.../5
Cancel
Up 0 Down

Cancel