This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AD provisioning to different OU's in IAM 7

 How can I do the exact same like it was in IAM 6:

 

https://www.quest.com/community/products/one-identity/f/identity-manager/6259/ad-provisioning-to-different-ous/16311?pi8709=1

 

Now, on Department > Edit IT operating data, there is no AD Container attribute.

There is also no config parm "TargetSystem\ADS\ADSContainer\ITDataFrom" like it was before.

What is the IAM 7 way to do it now?

Parents
  • We map location to ITOperatingData and provision by location. We are doing it as described below
    •ObjectKeyAppliesTo = XObjectKey of the ADSDomain (or TSBAccountDef) this mapping should be valid for
    •ObjectKeyValue = XObjectKey of the ADSContainer you are referring to
    •UID_DialogColumnTarget = UID of the DialogColumn that should use this value. In our case, the column ADSAccount.UID_ADSContainer.
    •UID_Org = UID of the location (In your case it will be department)

    Hope this helps
Reply
  • We map location to ITOperatingData and provision by location. We are doing it as described below
    •ObjectKeyAppliesTo = XObjectKey of the ADSDomain (or TSBAccountDef) this mapping should be valid for
    •ObjectKeyValue = XObjectKey of the ADSContainer you are referring to
    •UID_DialogColumnTarget = UID of the DialogColumn that should use this value. In our case, the column ADSAccount.UID_ADSContainer.
    •UID_Org = UID of the location (In your case it will be department)

    Hope this helps
Children
No Data