Initial Synchronization

Hi,

I used the OOTB AD connector and did the AD Initial Synchronization and users, groups, containers, and OUs are aggregated into the OneIM database. Now I'm adding the new users in AD OU and simulating the AD Initial Synchronization users are not inserting ( there are no operations logged for the simulation) into the OneIM database and not getting any error.

Can anyone tell me what could be the issue?

Thanks,

0 Troy Grandy over 2 years ago

Is it for a different OU than what we previously used for the first initial synchronization? What if you open the target system browser in the synchronization editor, do you see those new objects?
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 saurabh g over 2 years ago in reply to Troy Grandy

Hi,

It is resolved now. I created a new workflow. Now it's working.

Thanks
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 rachelgomez161999 over 2 years ago

If an individual row fails to be synchronized, you can't resync only that individual row. The first run of initial synchronization pushes the whole data set. This behavior is known as a full push. When change tracking is enabled in finance and operations apps, the subsequent runs are an incremental push that is based on the last run map version. When change tracking is disabled, subsequent runs cause a full push. During the incremental push, the error records won't be considered for resubmission.

Regards,

Rachel Gomez
Cancel
Up 0 Down

Reply

Verify Answer

Cancel