Initial Synchronization

Hi,

I used the OOTB AD connector and did the AD Initial Synchronization and users, groups, containers, and OUs are aggregated into the OneIM database. Now I'm adding the new users in AD OU and simulating the AD Initial Synchronization users are not inserting ( there are no operations logged for the simulation) into the OneIM database and not getting any error.

Can anyone tell me what could be the issue?

Thanks,

Parents
  • If an individual row fails to be synchronized, you can't resync only that individual row. The first run of initial synchronization pushes the whole data set. This behavior is known as a full push. When change tracking is enabled in finance and operations apps, the subsequent runs are an incremental push that is based on the last run map version. When change tracking is disabled, subsequent runs cause a full push. During the incremental push, the error records won't be considered for resubmission.

    Regards,

    Rachel Gomez

Reply
  • If an individual row fails to be synchronized, you can't resync only that individual row. The first run of initial synchronization pushes the whole data set. This behavior is known as a full push. When change tracking is enabled in finance and operations apps, the subsequent runs are an incremental push that is based on the last run map version. When change tracking is disabled, subsequent runs cause a full push. During the incremental push, the error records won't be considered for resubmission.

    Regards,

    Rachel Gomez

Children
No Data