SPS HA on different sites

Hi,

HA mode is supported for Hardware SPS appliances only and requires a physical direct connection to each other (not via network).

You would need to connect the two SPS hardware units with an Ethernet cable via the Ethernet ports 4 

Please refer to SPS installation guide here:

https://support.oneidentity.com/technical-documents/one-identity-safeguard-for-privileged-sessions/7.5/installation-guide/2#TOPIC-2157949

Thanks!

thanks for the answer Tawfiq, but in that case we can't deploy one node in DR side.

SPS has another cluster type (Configuration Synchronization Cluster) where you can sync the configuration only from Central Management node to 1 or more Managed Host nodes in different locations then if you want to have HA mode for each SPS node running in the Configuration cluster then you will need two HA pair nodes per location correct.

https://support.oneidentity.com/technical-documents/one-identity-safeguard-for-privileged-sessions/7.5/scalability-and-high-availability-in-safeguard#TOPIC-2158396

SPS has another cluster type (Configuration Synchronization Cluster) where you can sync the configuration only from Central Management node to 1 or more Managed Host nodes in different locations then if you want to have HA mode for each SPS node running in the Configuration cluster then you will need two HA pair nodes per location correct.

https://support.oneidentity.com/technical-documents/one-identity-safeguard-for-privileged-sessions/7.5/scalability-and-high-availability-in-safeguard#TOPIC-2158396

ok thanks