swagger

Question

i am following this KB: 
 Error when updating service account for Asset Discovery Rule, "Specify either an Account by ID or credentials, not both. (60409) (329320) (oneidentity.com) 
 i have to perform a PUT in this path /v3/AssetPartitions/{id}/DiscoveryJobs/{jobId} but i have diffucult to find the jobId. 
 in which path i can find it? 
 then i have the name of the service account but where i can find the Account Id also? 
 i have difficult to follow this KB that not help me at best. 
 Please can you help me?

Tawfiq.Ahmad · Answer

Hi Dario, 
 To execute the PUT /v3/AssetPartitions/{id}/DiscoveryJobs/{jobId} 
 You will need the following: 1. Asset Partition ID - you can get this from GET ​/v3​/AssetPartitions - In fields, select to show: Id,name - Note the Id here will be the Partition id. 
 2. Discovery Job ID: - you can get this from GET ​/v3​/AssetPartitions​/{id}​/DiscoveryJobs - In fields, select to show: Id,name - Note the Id here will be the job id for Asset Discovery. 
 3. The Directory service account id to be set: - you can get this from GET ​/v3​/AssetAccounts - Filter by Name ieq 'Username' - In fields, select to show: Id,name 
 4. Using the Partition id and Discovery Job id from steps 1 and 2 above: - Run a GET ​/v3​/AssetPartitions​/{id}​/DiscoveryJobs​/{jobId} - This will give you the body that you will need to update - Copy the response to notepad to modify the connection properties section. 
 - I tested by removing the below 4 lines: 
 "ServiceAccountUniqueObjectId": "", "ServiceAccountSecurityId": "", "ServiceAccountDistinguishedName": "", "EffectiveServiceAccountDistinguishedName": "", 
 - updated the following lines to the new service account: 
 "ServiceAccountId": ##, "EffectiveServiceAccountName": "Username", 
 
 Thanks!

Endpoint Privilege Management

swagger